FatPlate ArcMat

Programme Your Stroke For Absolute Precision With FatPlate ArcMat. FatPlate ArcMat (Technical side) stroke track contrast gives you a strong visual pathway within which to move your club whilst the sweetspot arc, stroke track & numbered face angle lines give complete guidance throughout the stroke.. By removing the sweetspot arc, face angle lines & square face setup line, ArcMat’s transitional side then becomes the perfect bridge between technical training & the natural appearance of the green.. Fine Tune Your Set-up For Consistent Results. The ball locator and face line ensure for correct alignment at set-up whilst the visual contrast between the bottom stroke arc & leading straight edge of ArcMat highlights how your arc appears relative to square.. Additional Features & Benefits?. Can be used in conjunction with PuttPlate.. Technical Side:ArcMat’s sweetspot arc, stroke track, numbered face angle lines & setup alignment give complete guidance throughout the stroke whilst the start line gates offer feedback after impact.. Transitional Side:By removing the sweetspot arc, face angle lines & square face setup line, ArcMat’s transitional side becomes the perfect bridge between technical training & the natural appearance of the green.. Sweetspot ArcThe sweetspot arc has been precisely measured to give guidance throughout the stroke, leading to a centered strike.. Stroke TrackArcMat’s stroke track contrast gives you a strong visual pathway within which to move your club.. Face Angle / Swing Length LinesThe face angle lines has been precisely measured to give guidance throughout the stroke, whilst the numbers on the swing length lines allow you to work on the relationship between the length of your backswing and thru-swing.. Start Line GateWork on controlling the ball’s starting direction by placing the tees provided into 1 of 3 positions respectively, giving an approximate start line accuracy of 1.0, 0.75 or 0.5 degrees (as you progress).. Ball Locator & Setup LineThe ball locator and face line ensure for correct alignment at setup.. AlignmentThe visual contrast between the bottom stroke arc & leading straight edge of ArcMat highlights how your arc appears relative to square.. Comes with our own specially manufactured flat-bottomed stub-tees that also allow you to work on start-line & impact drills indoors!. Available in 3 stroke arcs: Straight, Slight or Strong.. Carry your golf coach around in your pocket!. Which stroke arc is right for me?. The most common stroke tends to be Slight but there are a number of ways that you can check:. 1. Match the correct model to your putter:-. Face-balanced putters: straight arc.. Slightly toe weighted: slight arc. More toe weighted: strong arc. (If you’re not sure then a quick internet search should be able to confirm the weighting in your putter.). 2. By personal preference & feel.. If you prefer to rock your shoulders & swing straight back & through then opt for an FatPlate ArcMat Straight. If you like to feel an exaggerated stroke arc then opt for FatPlate ArcMatStrong. If you're anywhere in between the two previous beliefs then opt for FatPlate ArcMat Slight.. 3. If you're still unsure then this way can be just as effective.Simply ask a buddy to crouch down behind you whilst you make a few practice strokes and look to see if your stroke is straight, slightly arced or strongly arced.. How do I flatten out my FatPlate ArcMat?. After removing ArcMat from the tube & gently roll it in the opposite direction until the ‘curl memory’ has sufficiently weakened and then place on it the ground with the technical side facing you.. ArcMat is required to be rolled for transportation purposes, and, whilst any rolled substrate is susceptible to ‘curl memory’, our extensive R&D testing & industry knowledge have ensured that we use very best material & most suitable material available.. N.B. We suggest that you store your ArcMat with the technical side facing outwards when placed back inside the protective tube.. What are the miss tolerances of the start line tees?. As with PuttPlate, ArcMat’s start line gate positions offer a 3.7mm, 2.7mm or 1.7mm clearance (either side of the ball), giving an approximate start line accuracy of 1.0, 0.75 or 0.5 degrees.